Users Guide

2. Configure routing on the virtual network.
OS10(config)# interface virtual-network 500
OS10(conf-if-vn-10000)# ip vrf forwarding tenant1
OS10(conf-if-vn-10000)# ip address 10.5.0.231/16
3. Configure a static route for outbound traffic sent to the anycast MAC address of the dedicated virtual network.
OS10(config)#ip route 0.0.0.0/0 10.5.0.100
VTEP 2 Leaf Switch
1. Configure a dedicated VXLAN virtual network.
OS10(config)# virtual-network 500
OS10(config-vn-500)# vxlan-vni 500
OS10(config-vn-vxlan-vni)# exit
OS10(config-vn-10000)# exit
2. Configure routing on the virtual networks.
OS10(config)# interface virtual-network 500
OS10(conf-if-vn-10000)# ip vrf forwarding tenant2
OS10(conf-if-vn-10000)# ip address 10.5.0.232/16
3. Configure a static route for outbound traffic sent to the anycast MAC address of the dedicated virtual network.
OS10(config)#ip route 0.0.0.0/0 10.5.0.100
VTEP 3 Leaf Switch
1. Configure a dedicated VXLAN virtual network.
OS10(config)# virtual-network 500
OS10(config-vn-500)# vxlan-vni 500
OS10(config-vn-vxlan-vni)# exit
OS10(config-vn-10000)# exit
2. Configure an anycast gateway MAC address on the boder leaf VTEP. This MAC address must be different from
the anycast gateway MAC address configured on non-border-leaf VTEPs.
OS10(config)# ip virtual-router mac-address 00:02:02:02:02:02
3. Configure routing on the virtual network.
OS10(config)# interface virtual-network 500
OS10(conf-if-vn-10000)# ip vrf forwarding tenant1
OS10(conf-if-vn-10000)# ip address 10.5.0.233/16
OS10(conf-if-vn-10000)# ip virtual-router address 10.5.0.100
OS10(conf-if-vn-10000)# no shutdown
OS10(conf-if-vn-10000)# exit
4. Configure externally connected VLAN.
OS10(conf)#interface vlan 200
OS10(conf-if-vlan)#ip address 10.10.0.1/16
OS10(conf-if-vlan)#no shutdown
OS10(conf-if-vlan)#exit
OS10(conf)#interface ethernet 1/1/7
switchport mode trunk
switchport trunk allowed vlan 200
VXLAN
1251