Users Guide

Example
OS10# clear ipv6 access-list counters
Supported
Releases
10.2.0E or later
clear mac access-list counters
Clears counters for a specific or all MAC access lists.
Syntax
clear mac access-list counters [access-list-name]
Parameters access-list-name — (Optional) Enter the name of the MAC access list to clear counters. A
maximum of 140 characters.
Default Not configured
Command Mode EXEC
Usage
Information
If you do not enter an access-list name, all MAC access-list counters clear. The counter counts the
number of packets that match each permit or deny statement in an access list. To get a more recent
count of packets matching an access list, clear the counters to start at zero. To view access-list
information, use the show access-lists command.
Example
OS10# clear mac access-list counters
Supported
Releases
10.2.0E or later
deny
Configures a filter to drop packets with a specific IP address.
Syntax
deny [protocol-number | icmp | ip | tcp | udp] [A.B.C.D | A.B.C.D/x | any |
host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture |
count | dscp value | fragment | log]
Parameters
● protocol-number — (Optional) Enter the protocol number identified in the IP header, from 0 to
255.
● icmp — (Optional) Enter the ICMP address to deny.
● ip — (Optional) Enter the IP address to deny.
● tcp — (Optional) Enter the TCP address to deny.
● udp — (Optional) Enter the UDP address to deny.
● A.B.C.D — Enter the IP address in dotted decimal format.
● A.B.C.D/x — Enter the number of bits to match to the dotted decimal address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
● host ip-address — (Optional) Enter the keyword and the IP address to use a host address only.
● capture — (Optional) Capture packets the filter processes.
● count — (Optional) Count packets the filter processes.
● byte — (Optional) Count bytes the filter processes.
● dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
● fragment — (Optional) Use ACLs to control packet fragments.
● log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV4-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes
increment. The no version of this command removes the filter.
1476 Access Control Lists