Users Guide
Parameters access-list-name — Enter the name of an IPv6 access list. A maximum of 140 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
None
Example
OS10(config)# ipv6 access-list acl6
Supported
Release
10.2.0E or later
ipv6 prefix-list deny
Creates a prefix list to deny route filtering from a specified IPv6 network address.
Syntax
ipv6 prefix-list prefix-list-name deny {A::B/x [ge | le] prefix-len}
Parameters
● prefix-list-name — Enter the IPv6 prefix list name.
● A::B/x — Enter the IPv6 address to deny.
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix list.
Example
OS10(config)# ipv6 prefix-list TEST deny AB10::1/128 ge 10 le 30
Supported
Release
10.3.0E or later
ipv6 prefix-list description
Configures a description of an IPv6 prefix-list.
Syntax
ipv6 prefix-list name description
Parameters
● name — Enter the name of the IPv6 prefix-list.
● description — Enter the description for the named prefix-list.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix list.
Example
OS10(config)# ipv6 prefix-list TEST description TEST_LIST
Supported
Release
10.3.0E or later
1490 Access Control Lists