Users Guide
ipv6 prefix-list permit
Creates a prefix-list to permit route filtering from a specified IPv6 network address.
Syntax
ipv6 prefix-list prefix-list-name permit {A::B/x [ge | le] prefix-len}
Parameters
● prefix-list-name — Enter the IPv6 prefix-list name.
● A::B/x — Enter the IPv6 address to permit.
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ipv6 prefix-list TEST permit AB20::1/128 ge 10 le 30
Supported
Release
10.3.0E or later
ipv6 prefix-list seq deny
Configures a filter to deny route filtering from a specified prefix-list.
Syntax
ipv6 prefix-list [name] seq num deny {A::B/x [ge | le] prefix-len}
Parameters
● name — (Optional) Enter the name of the IPv6 prefix-list.
● num — Enter the sequence number of the specified IPv6 prefix-list.
● A::B/x — Enter the IPv6 address and mask in /prefix format (/x).
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ipv6 prefix-list TEST seq 65535 deny AB20::1/128 ge 10
Supported
Release
10.3.0E or later
ipv6 prefix-list seq permit
Configures a filter to permit route filtering from a specified prefix-list.
Syntax
ipv6 prefix-list [name] seq num permit A::B/x [ge | le} prefix-len
Parameters
● name — (Optional) Enter the name of the IPv6 prefix-list.
● num — Enter the sequence number of the specified IPv6 prefix list.
● A::B/x — Enter the IPv6 address and mask in /prefix format (/x).
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Access Control Lists 1491