Users Guide

show vlan
Displays the current VLAN configuration.
Syntax
show vlan [vlan-id]
Parameters vlan-id — (Optional) Enter a VLAN ID, from 1 to 4093.
Default Not configured
Command Mode EXEC
Usage
Information
None
Example
OS10# show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring
VLANs
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
1 down
Supported
Releases
10.2.0E or later
shutdown
Disables an interface.
Syntax
shutdown
Parameters None
Default Disabled
Command Mode INTERFACE
Usage
Information
This command marks a physical interface as unavailable for traffic. Disabling a VLAN or a port-channel
causes different behavior. When you disable a VLAN, the L3 functions within that VLAN are disabled, and
L2 traffic continues to flow. Use the shutdown command on a port-channel to disable all traffic on the
port-channel, and the individual interfaces. Use the no shutdown command to enable a port-channel on
the interface. The shutdown and description commands are the only commands that you can
configure on an interface that is a port-channel member.
Example
OS10(config)# interface ethernet 1/1/7
OS10(conf-if-eth1/1/7)# no shutdown
Supported
Releases
10.2.0E or later
speed (Fibre Channel)
Configures the transmission speed of a Fibre Channel interface.
Syntax
speed {8 | 16 | 32 | auto}
Parameters Set the speed of a Fibre Channel interface to:
● 8 — 8GFC
● 16 — 16GFC
● 32 — 32GFC
● auto — Set the port speed to the speed of the installed media.
Defaults Auto
414 Interfaces