Users Guide

Command Mode INTERFACE
Usage
Information
● To configure oversubscription for bursty storage traffic on a FC interface, use the speed command.
Oversubscription allows a port to operate faster, but may result in traffic loss. For example, QSFP28
port groups in 4x8GFC mode support 16GFC oversubscription on member interfaces. QSFP28
breakout interfaces in 4x16GFC mode support 32GFC oversubscription.
● The no version of this command resets the port speed to the default value auto.
Example
OS10(conf-if-fc-1/1/2)# speed 16
Supported
Releases
10.3.1E or later
speed (Management)
Configures the transmission speed of the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
Parameters Set the Management port speed to:
● 10 — 10M
● 100 — 100M
● 1000 — 1000M
● auto — Set the port to auto-negotiate speed with a connected device.
Defaults Auto
Command Mode INTERFACE
Usage
Information
● When you manually configure the Management port speed, match the speed of the remote device.
Dell EMC highly recommends using auto-negotiation for the Management port.
● The no version of this command resets the port speed to the default value auto.
Example
OS10(conf-if-ma-1/1/1)# speed auto
Supported
Releases
10.3.0E or later
stats-monitor
Configures the polling interval for Ethernet interface counters.
Syntax
stats-monitor stat-type ethernet polling-interval interval-value
Parameters interval-value—Enter the polling interval value, from 1 s to 15 s.
Defaults 15 s
Command Mode CONFIGURATION
Usage
Information
The no version of this command resets the configuration to the default value.
Example
stats-monitor stat-type ethernet polling-interval 1
Supported
Releases
10.5.2.1 or later
Interfaces 415