Users Guide

Upgrade commands
boot system
Sets the boot image to use for the next reboot.
Syntax
boot system {active | standby}
Parameters
● active — Reset the running image as the next boot image.
● standby — Set the standby image as the next boot image.
Default Active
Command Mode EXEC
Usage
Information
Use this command to configure the location of the OS10 image used to reload the software at boot time.
Use the show boot command to view the configured next boot image. This command applies
immediately and does not require the commit command.
Example
OS10# boot system standby
Supported
Releases
10.2.0E or later
image cancel
Cancels an image or firmware file download that is in progress.
Syntax
image cancel
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
The image cancel command cancels a file download from a server, such as an OS10 binary image or
firmware upgrade, that is in progress. After an image download completes, the command has no effect.
The command also removes any pending firmware upgrades on the switch.
Example
OS10# image cancel
Supported
Releases
10.2.0E or later
image copy
Copies the active image to the standby location.
Syntax
image copy active-to-standby
Parameters active-to-standby—Enter to copy the entire active image to the standby location, a mirror image.
Default Not configured
Command Mode EXEC
Usage
Information
Duplicate the active, running software image to the standby image location.
Example
OS10# image copy active-to-standby
46 Getting Started with Dell EMC SmartFabric OS10