Users Guide
Parameters
● high—Enter high to set the DRP value as high.
● low—Enter low to set the DRP value as low.
● medium—Enter medium to set the DRP value as medium.
Default None
Command Mode RA GUARD POLICY LIST CONFIGURATION
Usage
Information
The DRP value is lower than or equal to the specified limit. If you do not configure this command, the
system bypasses this verification. The no form of this command removes the configuration.
Example
OS10(conf-ra_guard_policy_list)# router-preference maximum high
Supported
Releases
10.5.2.0 or later
show config
Displays the RA guard policy mode configurations.
Syntax
show config
Parameters None
Command Mode RA GUARD POLICY LIST CONFIGURATION
Usage
Information
This command displays the following information about the applied RA guard policy:
● Device role
● Hop limit
● MTU
● Other configuration parameter flag
● Reachability time
● Retransmission timer value
● Router preference value
Example
OS10(conf-ra_guard_policy_list)# show config
!
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum 254
mtu 1280
other-config-flag on
reachable-time 100
retrans-timer 100
router-preference maximum medium
Supported
Releases
10.5.2.0 or later
show ipv6 nd ra-guard policy
Displays the configurations applied on all RA guard policies or a specific RA guard policy.
Syntax
show ipv6 nd ra-guard policy policy-name
Parameters policy-name—Name of the policy.
Command Mode EXEC
Usage
Information
None
Example
OS10# show ipv6 nd ra-guard policy test
ipv6 nd ra-guard policy test
912 Layer 3