Users Guide

Usage
Information
The no version of this command disables Helper mode.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# graceful-restart role helper-only
Supported
Releases
10.3.0E or later
ip ospf area
Attaches an interface to an OSPF area.
Syntax
ip ospf process-id area area-id
Parameters
● process-id — Set an OSPF process ID for a specific OSPF process, from 1 to 65535.
● area area-id — Enter the OSPF area ID in dotted decimal A.B.C.D format or enter an area ID
number, from 1 to 65535.
Default Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command removes an interface from an OSPF area.
Example
OS10(conf-if-vl-10)# ip ospf 10 area 5
Supported
Releases
10.2.0E or later
ip ospf authentication-key
Configures a text authentication key to enable OSPF traffic on an interface.
Syntax
ip ospf authentication-key key
Parameters key — Enter an eight-character string for the authentication key.
Defaults Not configured
Command Mode INTERFACE
Usage
Information
To exchange OSPF information, all neighboring routers in the same network must use the same
authentication key. The no version of this command deletes the authentication key.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ip ospf authentication-key sample
Supported
Releases
10.3.0E or later
ip ospf cost
Changes the cost associated with the OSPF traffic on an interface.
Syntax
ip ospf cost cost
Parameters cost — Enter a value as the OSPF cost for the interface, from 1 to 65335.
Default Based on bandwidth reference
Command Mode INTERFACE
944 Layer 3