Specifications

Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 3
Transceiver: internal
Auto-negotiation: on
MDI-X: off (auto)
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
pltool
To test functionality of the CPLD and FPGA devices on the boards during startup, use the pltool.
The pltool also checks for the correct rmware loads. The tool uses the CLI to list the devices and their registers, and allows you to read
and write registers in the device. The read functionality prints the details to the bit level and also any bit groupings and their meanings. The
tool uses the SDI interface to get a list of devices and registers in the system, and then uses SDI to access the devices.
Tests
The pltool tests specied registers and values SDI identies in the testable bits of the register. The tool reads the register using SDI
interfaces and compares the testable bits from those bits the SDI database provides. If a mismatch occurs, an error displays.
CLI options
Syntax: pltool <option>
Show this help text:=
pltool --h (or)
pltool -h
Test (RW) the scratchpad registers:=
pltool --test (or)
pltool -t
List devices and registers:=
pltool --list [--lstype=<devicetype>] (or)
pltool -l [-T <devicetype>]
List device names with address:=
pltool --listdevicenames [--devname=<devicename>] (or)
pltool -L [-n <devicename>]
Execute repeatedly command by count:=
pltool --iteration=max/<count> [option1] [option2]... (or)
pltool -I max/<count> [option1] [option2]...
Read the specified register of the device:=
pltool --read --devname=<devicename> --dev=<deviceaddr> --reg=<register> (or)
pltool -r -n <devicename> -D <deviceaddr> -R <register>
Write at the specified register of the device:=
pltool --write --devname=<devicename> --dev=<deviceaddr> --reg=<register> --val=<value>
(or)
pltool -w -n <devicename> -D <deviceaddr> -R <register> -V <value>
Dump all of the registers in a device or all devices and thei rcurrent values:=
pltool --dump [--devname=<devicename>] [--dev=<deviceaddr>] (or)
pltool -d [-n <devicename>] [-D <deviceaddr>]
Usage:=
-h, --h Show the help text
-t, --test Test using the pre-programmed configuration or use supplied config
-l, --list List the understood TLV codes and names
-T, --lstype Device type
Dell EMC DiagOS tools
69