Reference Guide

Supported
Releases
10.2.0E or later
lldp timer
Configures the rate (in seconds) at which LLDP packets send to the peers.
Syntax
lldp timer seconds
Parameters seconds — Enter the LLDP timer rate in seconds (5 to 254).
Default 30 seconds
Command Mode CONFIGURATION
Usage
Information
The no version of this command sets the LLDP timer back to its default value.
Example
OS10(config)# lldp timer 25
Supported
Releases
10.2.0E or later
lldp tlv-select basic-tlv
Enables or disables TLV attributes to transmit and receive LLDP packets.
Syntax
lldp tlv-select basic-tlv {port-description | system-name | system-
description | system-capabilities | management-address}
Parameters
● port-description — Enable or disable the port description TLV.
● system-name — Enable or disable the system TLV.
● system-description — Enable or disable the system description TLV.
● system-capabilities — Enable or disable the system capabilities TLV.
● management-address — Enable or disable the management address TLV.
Default Enabled
Command Mode INTERFACE
Usage
Information
None
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
Supported
Releases
10.2.0E or later
lldp tlv-select dot1tlv
Enables or disables the dot.1 TLVs to transmit in LLDP packets.
Syntax
lldp tlv-select dot1tlv { port-vlan-id | link-aggregation}
Parameters
● port-vlan-id — Enter the port VLAN ID.
● link-aggregation — Enable the link aggregation TLV.
Default Enabled
Command Mode INTERFACE
Usage
Information
The lldp tlv-select dot1tlv link-aggregation command advertises link aggregation as a
dot1 TLV in the LLDPDUs. The no version of this command disables TLV transmissions.
Layer 2 185