Reference Guide

Parameters query-interval-time—Enter the query time interval in milliseconds, ranging from 100 to 65535.
Default 1000 milliseconds
Command Mode VLAN INTERFACE
Usage
Information
The no version of this command resets the last member query interval time to the default value.
Example
OS10(config)# interface vlan 100
OS10(conf-if-vl-100)# ip igmp snooping last-member-query-interval 2500
Supported
Releases
10.4.1.0 or later
ip igmp snooping mrouter
Enables IGMP querier on the specified VLAN interface.
Syntax
ip igmp snooping mrouter interface interface—type
Parameters interface—type—Enter the interface type details. The interface should be a member of the VLAN.
Default Not configured
Command Mode VLAN INTERFACE
Usage
Information
The no version of this command removes the multicast router configuration from the VLAN member port.
Example
OS10(config)# interface vlan 100
OS10(conf-if-vl-100)# ip igmp snooping mrouter interface ethernet 1/1/1
Supported
Releases
10.4.0E(R1) or later
ip igmp snooping querier
Enables IGMP querier processing for the specified VLAN interface.
Syntax
ip igmp snooping querier
Parameters None
Default Not configured
Command Mode VLAN INTERFACE
Usage
Information
The no version of this command disables the IGMP querier on the VLAN interface..
Example
OS10(config)# interface vlan 100
OS10(conf-if-vl-100)# ip igmp snooping querier
Supported
Releases
10.4.0E(R1) or later
ip igmp snooping query-interval
Configures time interval for sending IGMP general queries.
Syntax
ip igmp snooping query-interval query-interval-time
Parameters query-interval-time—Enter the interval time in seconds, ranging from 2 to 18000.
366 Layer 3