Reference Guide

Supported
Releases
10.2.0E or later
domain-name
Configures the name of the domain where the device is located.
Syntax
domain-name domain-name
Parameters domain-name — Enter the name of the domain (up to 32 characters).
Default Not configured
Command Mode DHCP-POOL
Usage
Information
This is the default domain name that appends to hostnames that are not fully qualified. The no version of
this command removes the configuration.
Example
OS10(conf-dhcp-Dell)# domain-name dell.com
Supported
Releases
10.2.0E or later
hardware-address
Configures the client hardware address for manual configurations.
Syntax
hardware-address nn:nn:nn:nn:nn:nn
Parameters nn:nn:nn:nn:nn:nn — Enter the 48-bit hardware address.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
The client hardware address is the MAC address of the client machine to which to lease a static IP
address from.
Example
OS10(conf-dhcp-static)# hardware-address 00:01:e8:8c:4d:0a
Supported
Releases
10.2.0E or later
host
Assigns a host to a single IPv4 or IPv6 address pool for manual configurations.
Syntax
host A.B.C.D/A::B
Parameters A.B.C.D/A::B — Enter the host IP address in A.B.C.D or A::B format.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
The host address is the IP address used by the client machine for DHCP.
Example
OS10(conf-dhcp-Dell)# host 20.1.1.100
Supported
Releases
10.2.0E or later
470 System management