Reference Guide

Eth 1/1/5(Dwn) Eth 1/1/9:2(Dwn) Eth 1/1/9:3(Dwn)
OS10(conf-uplink-state-group-1)# show configuration
!
uplink-state-group 1
downstream ethernet1/1/1-1/1/5
downstream ethernet1/1/9:2-1/1/9:3
upstream ethernet1/1/7:1
UFD commands
clear ufd-disable
Overrides the uplink-state group configuration and brings up the downstream interfaces.
Syntax
clear ufd-disable {interface interface-type | uplink-state-group group-id}
Parameters
● interface-type — Enter the interface type.
● group-id — Enter the uplink state group ID, from 1 to 32.
Default None
Command Mode EXEC
Usage
Information
This command manually brings up a disabled downstream interface that is in UFD-disabled error state.
After the downstream interface is up, it is not disabled until there are changes in the upstream interfaces.
This command does not have effect on downstream interfaces that are already up or interfaces that are
not part of the UFD group.
Example
OS10# clear ufd-disable interface ethernet 1/1/2
OS10# clear ufd-disable uplink-state-group 1
Supported
Releases
10.4.0E(R3) or later
defer-time
Configures timer to defer UFD actions on downstream ports.
Syntax
defer-time timer
Parameters timer— Enter the timer value in seconds, ranging from 1 to 120.
Default Disabled
Command Mode UPLINK-STATE-GROUP
Usage
Information
You can view the timer details configured using the show uplink-state-group [group-id]
detail command. The no version of this command disables the timer.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# defer-time 120
Supported
Releases
10.4.1.0 or later
System management 521