Reference Guide

Assign control-plane service-policy
OS10(config)# control-plane
OS10(conf-control-plane)# service-policy input copp1
View control-plane service-policy
OS10(conf-control-plane)# do show qos control-plane
Service-policy (input): copp1
View configuration
Use the show commands to display the protocol traffic assigned to each control-plane queue and the current rate-limit applied
to each queue. You can also use the show command output to verify the CoPP configuration.
View CoPP configuration
OS10# show qos control-plane
Service-policy (input): pmap1
View CMAP1 configuration
OS10# show class-map type control-plane cmap1
Class-map (control-plane): cmap1 (match-any)
View CoPP service-policy
OS10# show policy-map type control-plane
Service-policy(control-plane) input: pmap1
Class-map (control-plane): cmap1
set qos-group 6
police cir 200 bc 100 pir 200 be 100
View CoPP information
OS10# show control-plane info
Queue Rate Limit(in pps) Protocols
0 600
1 1000
2 300
3 1300
4 2000 VLT NDS
5 400 ARP_REQ IPV6_ICMP_REQ
6 400 ARP_RESP IPV6_ICMP IPV6_ICMP_RESP IPV4_ICMP SSH TELNET TACACS
NTP FTP
7 400 RSTP PVST MSTP LACP
8 600 DOT1X LLDP
9 600 IPV6_OSPF IPV4_BGP IPV4_OSPF
10 600 IPV6_DHCP IPV4_DHCP SERVICEABILITY
11 300 OPEN_FLOW
View CoPP statistics
OS10# show control-plane statistics
Queue Packets Bytes Dropped Packets Dropped Bytes
0 0 0 0 0
1 0 0 0 0
2 0 0 0 0
3 0 0 0 0
4 0 0 0 0
5 2 172 0 0
6 0 0 0 0
7 32048 2180484 0 0
8 14140 2569184 0 0
9 0 0 0 0
10 0 0 0 0
11 0 0 0 0
Quality of service
635