Reference Guide

Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
The no version of this command removes the bandwidth from the queue.
Example
Supported
Releases
10.4.0E(R1) or later
queue qos-group
Configures a dot1p traffic class to a queue.
Syntax
queue number [qos-group dot1p-values]
Parameters
● queue number — Enter the traffic single value queue ID (0 to 7).
● qos-group dot1p-values — (Optional) Enter either single, comma-delimited, or a hyphenated
range of dot1p values (0 to 7).
Default 0
Command Mode TRUST-MAP
Usage
Information
If the trust map does not define traffic class values to a queue, those flows are mapped to the default
queue (0). If some of the traffic class values are already mapped to an existing queue, you will receive an
error. The no version of this command returns the value to the default.
Example
OS10(conf-tmap-tc-queue-qos)# queue 2 qos-group 5
Supported
Releases
10.3.0E or later
random-detect (interface)
Assigns a WRED profile to the specified interface.
Syntax
random-detect wred-profile
Parameters wred-profile — Enter the name of an existing WRED profile.
Default Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command removes the WRED profile from the interface.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# random-detect test_wred
Supported
Releases
10.4.0E(R1) or later
random-detect (queue)
Assigns a WRED profile to the specified queue.
Syntax
random-detect wred-profile-name
Parameters wred-profile-name — Enter the name of an existing WRED profile.
Default Not configured
Quality of service 659