Users Guide

ip ospf priority
Sets the priority of the interface to determine the DR for the OSPF network.
Syntax
ip ospf priority number
Parameters number — Enter a router priority number, from 0 to 255.
Default 1
Command Mode INTERFACE
Usage
Information
When two routers attached to a network attempt to become the DR, the one with the higher router
priority takes precedence. The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/6)# ip ospf priority 4
Supported
Releases
10.2.0E or later
ip ospf retransmit-interval
Sets the retransmission time between lost LSAs for adjacencies belonging to the interface.
Syntax
ip ospf retransmit-interval seconds
Parameters seconds — Enter a value in seconds as the interval between retransmission, from 1 to 3600.
Default 5 seconds
Command Mode INTERFACE
Usage
Information
Set the time interval to a number large enough to avoid unnecessary retransmission. The no version of
this command resets the value to the default.
Example
OS10(conf-if-eth1/1/6)# ip ospf retransmit-interval 20
Supported
Releases
10.2.0E or later
ip ospf transmit-delay
Sets the estimated time required to send a link state update packet on the interface.
Syntax
ip ospf transmit-delay seconds
Parameters seconds — Set the time in seconds required to send a link-state update, from 1 to 3600.
Default 1 second
Command Mode INTERFACE
Usage
Information
When you set the ip ospf transmit-delay value, take into account the transmission and
propagation delays for the interface. The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5
Supported
Releases
10.2.0E or later
Layer 3 753