Users Guide

NOTE: Dell Technologies recommends that you configure the same timeout value on both the VLT
peer nodes.
The no form of this command resets the multicast peer-routing timer value to its default value of 300 s.
Example
OS10(config)# vlt-domain 255
OS10(conf-vlt-255)# multicast peer-routing-timeout 1200
Supported
Releases
10.5.2.0 or later
show vlt inconsistency ip mcache
Displays information about mismatched IIF routes between the local and peer VLT nodes.
Syntax
show vlt inconsistency ip mcache [vrf vrf-name]
Parameters vrf vrf-name—(Optional) Enter the keyword then the name of the VRF to display information about
mismatched IIF routes corresponding to that non-default VRF.
Default None
Command Mode EXEC
Usage
Information
None
Example
OS10# show vlt inconsistency ip mcache
Spanned Multicast routing IIF inconsistency:
Multicast Route Local IIF Peer IIF
(22.22.22.200, 225.1.1.2) Vlan 5 Vlan6
(*, 225.1.1.2) Vlan 15 ethernet 1/1/1
Supported
Releases
10.5.0 or later
show vlt mismatch
Displays configuration mismatch between VLT peers.
Syntax
show vlt {domain-id | all} mismatch
Parameters domain-id—Enter a VLT domain ID, from 1 to 255.
Default None
Command Mode EXEC
Usage
Information
The show vlt mismatch command displays multicast configuration mismatches.
Example
OS10# show vlt all mismatch
Multicast routing mismatches:
Global status:
Parameter VRF Local Peer
---------------------------------------------------------------------
V4 Multicast default Enabled Disabled
Vlan status IPv4 IPv6
VlanId Local Peer Local Peer
--------------------------------------------------------
Vlan 11 Enabled Disabled Disabled Disabled
Multicast 1111