Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4248FB-ON /S4248FBL-ON
131132133134135136137138139140
Table Of Contents
ztd start
Starts the ZTD process.
Syntax
ztd start
Parameters None
Default Not configured
Command Mode EXEC
Security and
Access
Sysadmin and secadmin
Usage
Information
When you enter this command, if there are any configuration changes, the system prompts you for a
confirmation to delete the startup configuration. If you have made configuration changes after the ZTD
process stops, the system reloads. This command is similar to the reload ztd command. However, if
you have not made any configuration changes after the ZTD process stops, this command does not reload
the switch. It starts only the ZTD process.
Example
OS10# ztd start
Supported
Releases
10.5.2.0 or later
ztd stop
Stops ZTD while in progress.
Syntax
ztd stop
Parameters None
Default Not configured
Command Mode EXEC
Security and
Access
Sysadmin and secadmin
Usage
Information
The system cancels the ZTD process when you enter CLI Configuration mode. The ztd stop and ztd
cancel commands perform the same function. Use this command only when ZTD is in a waiting state;
that is, before it receives an answer from the DHCP server. Otherwise, the command returns an error
message.
Example
OS10# ztd stop
Supported
Releases
10.5.2.0 or later
Dell EMC SmartFabric OS10 zero-touch deployment 133