Users Guide

Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ip prefix-list denyprefix deny 10.10.10.2/16 le 30
Supported
Release
10.3.0E or later
ip prefix-list permit
Creates a prefix-list to permit route filtering from a specified network address.
Syntax
ip prefix-list name permit [A.B.C.D/x [ge | le]] prefix-len
Parameters
● name — Enter the name of the prefix list.
● A.B.C.D/x — (Optional) Enter the source network address and mask in /prefix format (/x).
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ip prefix-list allowprefix permit 10.10.10.1/16 ge 10
Supported
Release
10.3.0E or later
ip prefix-list seq deny
Configures a filter to deny route filtering from a specified prefix list.
Syntax
ip prefix-list name seq num deny {A.B.C.D/x [ge | le] prefix-len}
Parameters
● name — Enter the name of the prefix list.
● num — Enter the sequence list number.
● A.B.C.D/x — Enter the source network address and mask in /prefix format (/x).
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix list.
Example
OS10(config)# ip prefix-list seqprefix seq 65535 deny 10.10.10.1/16 ge 10
Supported
Release
10.3.0E or later
1468 Access Control Lists