Users Guide

Examples
OS10(conf-support-assist)# activity event-notification enable
OS10(conf-support-assist)# activity full-transfer enable
Supported
Releases
10.2.0E or later
contact-company
Configures the company contact information.
Syntax
contact-company name company-name
Parameters company-name—Enter the contact company name.
Default Not configured
Command Mode SUPPORT-ASSIST
Usage
Information
You can enter only one contact company. This command takes you to a submode where you can provide
more company contact information.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0(R3S).
Also supported in SmartFabric mode starting in release 10.5.0.
The no version of this command removes the configuration.
Example
OS10(conf-support-assist)# contact-company name ExampleCompanyName
OS10(conf-support-assist-ExampleCompanyName)#
Supported
Releases
10.2.0E or later
server url
Configures the URL and port of the SupportAssist server and specifies the username and password needed for SupportAssist
server authorization.
Syntax
server url {default | server-url-string}
Parameters
● default—Enter the default to connect to the SupportAssist server (https://esrs3.emc.com).
● server-url-string—Enter the domain name or IP address of the SupportAssist server.
Default None
Command Mode SUPPORT-ASSIST
Security and
Access
sysadmin and secadmin
Usage
Information
Use this command to configure the URL of the support-assist server. Use the default value to
configure the production URL. The no version of this command removes the configuration.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0(R3S).
Also supported in SmartFabric mode starting in release 10.5.0.
Example
OS10(conf-support-assist)# server url default
<cr>
OS10(conf-support-assist)# server url https://test-esrs-server.com:443
<cr>
OS10(conf-support-assist)# server url https://esrs3stg.emc.com:443
<cr>
1792 Troubleshoot Dell EMC SmartFabric OS10