Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4248FB-ON /S4248FBL-ON
1811181218131814181518161817181818191820
Table Of Contents
Command mode CONFIGURATION
Usage
information
Use this command to specify the configured crypto security profile to use to send system messages to a
remote server over TLS. TLS requires an X.509v3 certificate-key pair installed on the switch.
Example
OS10(config)# logging security-profile prof1
Supported
releases
10.5.0 or later
logging server
Configures a remote syslog server.
Syntax
logging server {ipv4–address | ipv6–address} [tcp | udp | tls] [port-
number] [severity severity-level] [vrf {management | vrf-name]
Parameters
● ipv4–address | ipv6–address — (Optional) Enter the IPv4 or IPv6 address of the logging
server.
● tcp | udp | tls port-number — (Optional) Send syslog messages using TCP, UDP, or TLS
transport to a specified port on a remote logging server, from 1 to 65535.
● severity-level — (Optional) Set the logging threshold severity:
○ log-emerg — System is unusable.
○ log-alert — Immediate action is needed.
○ log-crit — Critical conditions
○ log-err — Error conditions
○ log-warning — Warning conditions
○ log-notice — Normal, but significant conditions (default)
○ log-info — Informational messages
○ log-debug — Debug messages
● vrf {management | vrf-name} — (Optional) Configure the logging server for the management
or a specified VRF instance.
Defaults
System logging to a remote server is not configured. When configured, system messages are sent over
UDP to port 514 on a remote logging server by default. System messages of severity-level log-notice
and lower are sent.
Command Mode CONFIGURATION
Usage
Information
Use the logging server command to forward log messages to syslog servers for storage.
The tls option requires that a valid security profile is already configured with the logging
security-profile command. If you delete the logging security profile, system messages are sent
using UDP (default) to a remote syslog server.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.5.0.0. Also
supported in SmartFabric mode starting in release 10.5.0.1.
The no version of this command deletes the syslog server.
Example
OS10(config)# logging server 10.11.86.139 severity log-info
OS10(config)# logging server fda8:6c3:ce53:a890::2 tcp 1468
OS10(config)# logging server 10.11.86.139 vrf management severity log-
debug
Supported
Releases
10.5.0 or later
1818 Troubleshoot Dell EMC SmartFabric OS10