Users Guide

Delay request messages received : 0
Delay response messages transmitted : 0
Delay response messages received : 74286
Management messages transmitted : 0
Management messages received : 0
Signaling messages transmitted : 0
Signaling messages received : 0
Interface : Ethernet1/1/23
Total number of peers : 1
Peer index : 0
Peer Clock Identity : 00:17:00:ff:fe:00:02:00
Peer Port number : 1
Peer Port Address : 23.0.0.2
Receiving Interface : ethernet1/1/23
Announce messages transmitted : 41207
Announce messages received : 0
Sync messages transmitted : 2637200
Sync messages received : 0
Follow up messages transmitted : 0
Follow up messages received : 0
Delay request messages transmitted : 0
Delay request messages received : 2389638
Delay response messages transmitted : 2389638
Delay response messages received : 0
Management messages transmitted : 0
Management messages received : 0
Signaling messages transmitted : 0
Signaling messages received : 0
View the PTP state and lock status
OS10# show ptp servo
Servo State : Locked
Lock Status : Phase-locked
Example: Configure boundary clock with L2 transport method
You must connect the grandmaster clock to one of the interfaces. In this example, interface 1 is connected to the grandmaster
clock.
Configure a boundary clock with two PTP interfaces using L2 transport method. The interface that is connected to the
grandmaster clock or the best master clock becomes the slave device. The other interface becomes the master clock.
1. Configure the PTP boundary clock.
The delay mechanism of the boundary clock is end-to-end by default.
OS10(config)# ptp clock boundary
System management
207