Users Guide

show ptp interface
Displays PTP information about the interface.
Syntax
show ptp interface [{ethernet node/slot/port[:subport]} | {port-channel
port-channel-id}]
Parameters
● ethernet node/slot/port[:subport]—Enter the Ethernet interface information.
● port-channel port-channel-id—Enter the port channel interface number.
Defaults None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
For boundary clocks, this command indicates if the port is enabled or disabled. This command is not
applicable for transparent clocks.
Example
OS10# show ptp interface
Interface : Ethernet1/1/22
PTP : Enabled
Port Identity : 68:4f:64:ff:ff:01:db:ec:1
Port State : Slave
Vlan :
Transport : Ipv4-multicast
Log Delay Request Minimum interval : -4
Log Announce Interval : 1
Announce Receipt Timeout Multiplier : 3
Log Sync Interval : -4
Delay Mechanism : End-to-end
Interface : Ethernet1/1/23
PTP : Enabled
Port Identity : 68:4f:64:ff:ff:01:db:ec:2
Port State : Master
Vlan :
Transport : Ipv4-multicast
Log Delay Request Minimum interval : -4
Log Announce Interval : 1
Announce Receipt Timeout Multiplier : 3
Log Sync Interval : -4
Delay Mechanism : End-to-end
Supported
Releases
10.5.1.0 or later
show ptp parent
Displays information about the local PTP parent and grandmaster clock.
Syntax
show ptp parent
Parameters None
Defaults None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
This command is not applicable for transparent clocks.
Example
OS10# show ptp parent
Parent Clock Idenitity : 00:16:00:ff:fe:00:02:00
Parent Port Number : 1
232 System management