Users Guide

Table Of Contents
Parameters None
Default None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
This command clears the active manual or force switched clock reference. Clearing the force-switch
reinitiates the clock selection process.
Example
OS10# clear sync-e switch
Supported
Releases
10.5.2.1 or later
clear sync-e wait-restore-time
Clears the wait-to-restore state of a specific interface or all interfaces.
Syntax
clear sync-e wait-restore-time [ethernet node/slot/port]
Parameters ethernet node/slot/port(Optional) Enter a physical Ethernet interface.
Default None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
Use this command to reset the timer for a specific interface or all the interfaces that are in the wait-
to-restore state. Clearing this timer makes the clock sources to be available for the selection process
immediately.
Example
OS10# clear sync-e wait-restore-time ethernet 1/1/1
Supported
Releases
10.5.2.1 or later
debug sync-e
Enables debug logs for G.781 and ESMC (G.8264).
Syntax
[no] debug sync-e {all | esmc | g781}
Parameters
allEnables all debug logs of the system.
esmcEnables ESMC-related debug logs.
g781Enables G.781-related debug logs.
Default None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
The debug log messages are logged in the /var/log/synce.log file.
Example
OS10# debug sync-e esmc
Supported
Releases
10.5.2.1 or later
System management 249