Users Guide

Table 7. New in 10.5.2.0
Revision Date Feature Description
● Configuration of local user authentication by smart card
with password
● Configuration of local user authentication by smart card
without a password
● Security profile settings used by X.509v3 authentication
● CLI commands
SNMP Source Interface SNMP source interface:
● Overview
● CLI command
RESTCONF request of CLI
command
PATCH failure case and the equivalent POST request
Anycast IP Gateway for VLANs Support for anycast IP gateway routing for VLANs:
● Description
● Deployment considerations
● Configuration
● CLI commands
Monitor CPU Utilization Configure the high or low CPU utilization threshold values.
Monitor Memory Utilization Configure the high or low memory utilization threshold
values.
Low Latency Modes Low latency mode is used to reduce the switching latency
for timing critical applications such as storage networks.
● Description
● Cut-through switching mode
● Restrictions and Limitations
● CLI commands
Debug FC commands The Debug FC commands are supported on all the modes.
● Description
● CLI commands
BGP auto-unnumbered interfaces Configure the switch to automatically establish BGP
sessions on interfaces that learn the link-local addresses of
peer devices.
● Auto-unnumbered interfaces for BGP
● Configure an auto-unnumbered neighbor
● Example auto-unnumbered BGP configuration
Dynamic route leaking across VRFs Dynamic route leaking across VRFs
Disable DHCP Option-82 Allows you to disable DHCP Option-82 on interfaces.
Delay-restore for orphan ports Delays the bring-up of non-VLT ports; so that, there is
enough time available for the protocols and features to
converge.
DHCP relay agent options Serves as an enhancement to the DHCP request and allows
the DHCP server to select a sub-range in the pool.
Optimize FCF rebalance Presents all available operational Fibre Channel uplinks in a
fabric as a single logical unit.
36 Change history