Users Guide

● INTERFACE RANGE ETHERNET CONFIGURATION submode
Usage
Information
By default, this command is enabled on all the physical interfaces. Use the no version of this command
to disable high-power optics on the interface or interfaces. If you disable high-power optics, this
configuration is displayed in the show running-configuration command output. This command
is applicable only for Z9332F-ON and Z9432F-ON platforms.
NOTE: When the Ethernet interface is in breakout configuration mode, this command is applicable
only for the first subinterface.
Security and
Access
Not applicable
Example
OS10(config)# interface ethernet 1/1/2:1
OS10(conf-if-eth1/1/2:1)# no allow high-wattage-optics
Supported
Releases
10.5.2.1 or later
show inventory media wattage
Displays wattage information of the optics present in the switch.
Syntax
show inventory media wattage
Parameters None
Default Not applicable
Command Mode EXEC
Usage
Information
Displays the following information for each port that has a pluggable media inserted on the Z9332F-ON
and Z9432F-ON platforms:
● Wattage of the pluggable optics read from the media EEPROM.
● Maximum power threshold on the port above which an optic is disabled on the interface.
● An field to indicate if the pluggable optic present in the port is a high-power optic or not.
● An field to indicate if the pluggable optic is enabled or disabled.
Security and
Access
Not applicable
Example
OS10# show inventory media wattage
-------------------------------------------
System Inventory Media wattage
------------------------------
Node/Slot Media Media-wattage Max-threshold High-power-media
/Port
-------------------------------------------------------------------------
1/1/1 Not Present
1/1/2 Not Present
1/1/3 Not Present
1/1/4 QSFP56-DD400GBASE 12.5W 15W Yes
-SR8-AOC-10.0M
1/1/5 QSFP56-DD400GBASE 9W 15W No
-SR8
--more--
Supported
Releases
10.5.2.1 or later
376 Interfaces