Users Guide

Usage
Information
The no version of this command disables the DOM traps.
Example
OS10# configure terminal
OS10(config)# snmp-server enable traps dom temperature
OS10# configure terminal
OS10(config)# no snmp-server enable traps dom temperature
Supported
Releases
10.4.3.0 or later
feature auto-breakout
Enables front-panel Ethernet ports to automatically detect SFP media and autoconfigure breakout interfaces.
Syntax
feature auto-breakout
Parameters None
Default Not configured
Command mode CONFIGURATION
Usage
information
After you enter the feature auto-breakout command and plug a supported breakout cable in a
QSFP+ or QSFP28 port, the port autoconfigures breakout interfaces for media type and speed.
Use the interface breakout command to manually configure breakout interfaces. The media type
plugged into a port is no longer automatically learned. The no version of this command disables the
auto-breakout feature.
Example
OS10(config)# feature auto-breakout
Supported
releases
10.4.0E(R1) or later
fec
Configures Forward Error Correction on 25G, 50G, and 100G interfaces.
Syntax
fec {CL74-FC | CL91-RS | CL108-RS | off}
Parameters
● CL74-FC — Supports 25G and 50G
● CL91-RS — Supports 100G
● CL108-RS — Supports 25G and 50G
● off — Disables FEC
Defaults
NOTE: Default FEC settings are determined by the inserted media type.
● For 25G and 50G interfaces: off, CL108-RS, or auto-negotiate
● For 100G interfaces: off, CL91-RS, or auto-negotiate
Command Mode CONFIGURATION
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# interface ethernet 1/1/41
OS10(conf-if-eth1/1/41)# fec CL91-RS
Supported
Releases
10.3.0E or later
Interfaces 385