Users Guide

Usage
Information
Use the do show interface description command to view interface description from other
command modes.
Example
OS10# show interface description
--------------------------------------------------------------------
Port OK Status Protocol Description
--------------------------------------------------------------------
Eth 1/1/1 NO admin down down connected-to-host
Eth 1/1/2 YES up up connected-to-server
Eth 1/1/3 NO up down connected-to-radius-server
Eth 1/1/4 NO up down
Eth 1/1/5 NO up down
Eth 1/1/6 NO up down
Supported
Releases
10.5.2.3 or later
show interface phy-eth
Displays the optical details for an interface.
Syntax
show interface phy-eth [interface] [transceiver]
Parameters
● interface—(Optional) Specify the interface corresponding to which you want to view the optical
details.
● transceiver—(Optional) Displays the transceiver details.
Defaults None
Command Mode EXEC
Usage
Information
Starting from Release 10.5.2.1, the interface and transceiver parameters are optional. If you do
not specify these parameters, this command displays the optical information for all the interfaces.
Example
OS10# show interface phy-eth 1/1/14 transceiver | grep "Tunable
wavelength"
SFP1/1/14 Tunable wavelength= 1530.000nm
Supported
Releases
10.4.2E or later
show interface switchport
Displays the physical and port channel interfaces that are VLAN bridge ports or switch ports.
Syntax
show interface switchport [interface]
Parameters interface—(Optional) Enter the interface type:
● ethernet node/slot/port[:subport]—Display Ethernet interface information.
● port-channel id-number—Display port channel interface IDs, from 1 to 128.
Default None
Command Mode EXEC
Usage
Information
Use this command to display the Layer 2 interfaces and their VLAN membership details.
Example
OS10# show interface switchport
Codes: A - Access (Untagged), T - Tagged
v - VLTi untagged, V - VLTi tagged
Interfaces 397