Users Guide

r_a_tov
Configures the R_A_TOV FC timer value for vfabric.
Syntax
r_a_tov timeout-val
Parameters
timeout-val—Valid values are from 5000 to 10000.
Defaults 10000ms
Command Mode VFabric CONFIGURATION
Usage
Information
● The configurations are supported only in multiswitch mode.
● This timer is used to mark the error conditions during domain ID allocation, SW-RSCN, and NS
QUERY. Match this value with the other end, during port initialization. This type of configuration is not
permitted when vfabric is active.
● If the configured R_A_TOV value is not the same on both the sides of the port, then the port is
isolated. Ensure to configure the same R_A_TOV value on both the sides.
● You can change the R_A_TOV value only when vfabric is in inactive state. You can activate the
vfabric only by adding VLAN and fcmap configuration under the vfabric configuration view. Ensure to
configure the R_A_TOV before configuring the vlan, and fcmap in the vfabric configuration view.
● The no version of this command resets to default value of 10000ms.
Example
OS10(conf-vfabric-<vfabric-id>)#r_a_tov 3000
Supported
Releases
10.5.1.0 or later
show fc fabric
Shows switches in the FC fabric.
Syntax
show fc fabric
Parameters None
Defaults Not applicable
Command Mode Fibre Channel INTERFACE
Usage
Information
● The configurations are supported only in multiswitch mode.
● This command specifies the retransmit time interval for unacknowledged link state updates.
● The no version of this command resets to the default value.
Example
OS10#show fc fabric
Number of FC Switches = 2
Vfabric-Id Domain ID Switch WWNN
---------------------------------------------------------------
100 0x02(02) *20:01:00:05:9b:00:11:5f
100 0x66(102) >10:00:00:05:1e:03:ae:56
> Principal
*Local Switch
Supported
Releases
10.5.1.0 or later
show fc fabric interface
Shows the summary of the principal switch election states, ILS link type, port state, reason code, remote switch, and port name.
Syntax
show fc fabric interface
Fibre Channel 447