Users Guide

Uplink Duplicate
Intf Upstream Fabric-Name Error Reason FC-Id(s)
-----------------------------------------------------------------
Fc 1/1/13 20:01:d4:ae:52:1a:ee:53 NONE 1
Fc 1/1/14 20:01:d4:ae:52:7d:aa:54 NONE 0
OS10#show npg uplink-interfaces vfabric 200 fcf-info
VFabric Id : 200
FAD Timeout Left : 10 second(s)
FCF Availability Status : No
Uplink Duplicate
Intf Upstream Fabric-Name Error Reason FC-Id(s)
-----------------------------------------------------------------
Fc 1/1/11 10:01:d4:ae:52:1a:ee:50 FLOGI_REJECTED 1
Fc 1/1/12 10:01:d4:ae:52:2b:ff:52 NONE 0
Supported
Releases
10.5.2.0 or later
Debug FC commands
The following commands are supported on all the modes: F_Port, NPG, FSB, and Multiswitch.
debug fc
Enables and disables the debug options for the FC module.
Syntax
debug fc {all | error| info | acl | port | tx | pse | ns | fspf | rx-{all
| disc | virt-inst | virt-mnt | vlan-disc | ns | pse | fspf | sw-rscn}
[interface {fibrechannel | ethernet} node | slot | portid]}
Parameters
● all—Enables debug messages for all FC debug log-levels.
● error—Enables error debug log messages.
● info—Enables information log messages.
● acl—Enables debug messages that relate to the Access Control List (ACL).
● port—Enables debug messages that relate to the interface.
● tx—Enables debug messages that are involved during packet transmission (Tx).
● pse—Enables debug messages that are generated during the Principal Switch Election (PSE) phase
of the Multi-switch mode.
● ns—Enables debug messages that are generated during the name server registration and
management process.
● fspf—Enables debug messages that are generated during the Fabric Shortest Path First (FSPF)
process of Multi-switch mode.
● rx—Enables debug messages that generate during packet reception (Rx) according to the specified
sublevels.
● disc—Enables debug messages corresponding to the Rx discovery packet.
● virt-inst—Enables debug messages corresponding to the Rx Virtual Link Instantiation frames.
● virt-mnt—Enables debug messages corresponding to the Rx Virtual Link Maintenance frames.
● vlan-disc—Enables debug messages corresponding to the Rx VLAN Discovery packet.
● sw-rscn—Enables debug messages that are involved during the Switch-Registered State Change
Notification(Sw-RSCN).
Default Disabled
Command Mode EXEC
Usage
Information
Before using this command, run the following commands:
520 Fibre Channel