Users Guide

ip address 10.1.1.1/24
4. Assign an IPv6 address to the interface.
INTERFACE CONFIGURATION
ipv6 address 1::1/64
You can also auto configure an IPv6 address using the ipv6 address autoconfig command.
Assign an interface back to the default VRF instance
Table 83. Configurations to be deleted
CONFIGURATION MODE COMMAND
IP address—In interface
configuration mode, undo the IP
address configuration.
INTERFACE CONFIGURATION
OS10(conf-if-eth1/1/10:1)#no ip address
ipv4-address or no ipv6 address ipv6–
address
Port—In interface configuration
mode, delete the interface
association corresponding to the
VRF instance that you want to
delete.
INTERFACE CONFIGURATION
OS10(conf-if-eth1/1/10:1)#no ip vrf
forwarding
To assign an interface back to the default VRF, perform the following steps:
1. Enter the interface that you want to assign back to the default VRF instance.
CONFIGURATION
interface ethernet 1/1/1
2. Remove the IPv4 address associated with the interface.
INTERFACE CONFIGURATION
no ip address
3. Remove the IPv6 address associated with the interface.
INTERFACE CONFIGURATION
no ipv6 address
4. Assign the interface back to the default VRF instance.
INTERFACE CONFIGURATION
no ip vrf forwarding
Assigning the management interface back to the default VRF instance
To assign the management interface back to the default VRF, perform the following steps:
1. Enter the management VRF instance.
CONFIGURATION
ip vrf management
2. Remove the IPv4 address associated with the interface.
INTERFACE CONFIGURATION
no ip address
3. Remove the IPv6 address associated with the interface.
INTERFACE CONFIGURATION
no ipv6 address
4. Assign the management interface back to the default VRF instance.
CONFIGURATION VRF
no interface management
726
Layer 3