Users Guide

Table Of Contents
router bgp
Enables BGP and assigns an AS number to the local BGP speaker.
Syntax
router bgp as-number
Parameters as-numberEnter the AS number range.
1 to 65535 in 2 byte
1 to 4294967295 in 4 byte
Default None
Command Mode CONFIGURATION
Usage
Information
The AS number can be a 16-bit integer. The no version of this command resets the value to the default.
Example
OS10(config)# router bgp 3
OS10(conf-router-bgp-3)#
Supported
Releases
10.3.0E or later
router-id
Assigns a user-given ID to a BGP router.
Syntax
router-id ip-address
Parameters ip-address Enter an IP address in dotted decimal format.
Default First configured IP address or random number
Command Mode ROUTER-BGP
Usage
Information
Change the router ID of a BGP router to reset peer-sessions. The no version of this command resets the
value to the default.
By default, OS10 sets a loopback IP address as the router ID. If there is no loopback address, the software
chooses the highest IP address that is configured to a physical interface.
NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-
CONFIG-VRF sub mode using the following commands:
1. Enter the ROUTER BGP mode using the router bgp as-number command.
2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name
command.
Example
OS10(conf-router-bgp-10)# router-id 10.10.10.40
Supported
Releases
10.3.0E or later
send-community
Sends a community attribute to a BGP neighbor or peer group.
Syntax
send-community {extended | standard}
Parameters
extended Enter an extended community attribute.
standard Enter a started community attribute.
Default Not configured
Command Mode ROUTER-NEIGHBOR
866 Layer 3