Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4248FB-ON /S4248FBL-ON
919293949596979899100
Table Of Contents
end
Returns to EXEC mode from any other command mode.
Syntax
end
Parameters None
Default Not configured
Command Mode All
Usage
Information
Use the end command to return to EXEC mode to verify currently configured settings with show
commands.
Example
OS10(config)# end
OS10#
Supported
Releases
10.2.0E or later
exit
Returns to the next higher command mode.
Syntax
exit
Parameters None
Default Not configured
Command Mode All
Usage
Information
None
Example
OS10(conf-if-eth1/1/1)# exit
OS10(config)#
Supported
Releases
10.2.0E or later
hostname
Sets the system host name.
Syntax
hostname name
Parameters name — Enter the host name of the switch, a maximum of 64 characters.
Default OS10
Command Mode CONFIGURATION
Usage
Information
The host name is used in the OS10 command-line prompt.
The MX7000 series switch, not the Dell EMC SmartFabric OS10, automatically sets the default hostname
using a module-slot format. To calculate the hostname, the switch takes into account the module that is
currently plugged into the MX7000 chassis and the slot in the chassis where the module is inserted. The
module can be either MX9116n or MX5108n.
NOTE: To make the switch automatically set the default hostname using the module-slot format,
before upgrading to version 10.5.0, remove the user-defined hostname or set the default hostname
using the no hostname command.
92 CLI Basics