Users Guide

● max-wait — Configure the maximum amount of hold time that can delay an SPF calculation, from 1 to 600000
milliseconds; default 10000.
Enable SPF throttling (OSPFv2)
OS10(config)# router ospf 100
OS10(config-router-ospf-100)# timers spf 1200 2300 3400
Enable SPF throttling (OSPFv3)
OS10(config)# router ospfv3 10
OS10(config-router-ospf-10)# timers spf 2000 3000 4000
View OSPFv2 SPF throttling
OS10(config-router-ospf-100)# do show ip ospf
Routing Process ospf 100 with ID 12.1.1.1
Supports only single TOS (TOS0) routes
It is Flooding according to RFC 2328
SPF schedule delay 1200 msecs, Hold time between two SPFs 2300 msecs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area (0.0.0.1)
Number of interface in this area is 1
SPF algorithm executed 1 times
View OSPFv3 SPF throttling
OS10(config-router-ospfv3-100)# timers spf 1345 2324 9234
OS10(config-router-ospfv3-100)# do show ipv6 ospf
Routing Process ospfv3 100 with ID 129.240.244.107
SPF schedule delay 1345 msecs, Hold time between two SPFs 2324 msecs
Min LSA origination 5000 msec, Min LSA arrival 1000 msec
Min LSA hold time 0 msec, Max LSA wait time 0 msec
Number of area in this router is 1, normal 1 stub 0 nssa
Area (0.0.0.1)
Number of interface in this area is 1
SPF algorithm executed 2 times
Redistribute routes
Add routes from other routing instances or protocols to the OSPFv2 process and include BGP, static, or connected routes in the
OSPFv2 process. Do not route IBGP routes to OSPFv2 unless there are route-maps associated with the OSPFv2 redistribution.
When you configure the system to redistribute BGP routes to OSPF, by default, the system redistributes only the external BGP
(eBGP) routes. Use the [no] bgp redistribute-internal command under BGP to allow or block the redistribution of
IPv4 or IPv6 internal BGP ((iBGP) routes to OSPF in a default or nondefault VRF instance. To know more information, see
Redistribute iBGP route to OSPF.
NOTE:
With the redistribute static command in the running configuration, if a static route is configured which is
also learned through OSPF, the static route is installed in the routing table even if the static route preference is higher than
OSPF.
● Enter the routes that redistribute into the OSPFv2 process in ROUTER-OSPF mode.
redistribute {bgp as-number| connected | static} [route-map map-name]
○ bgp | connected | static—Enter a keyword to redistribute those routes.
○ route-map map-name—Enter the name of a configured route map.
Layer 3
937