Users Guide

Table Of Contents
112.112.112.1 -/B/-/ 2 110.1.1.2 Vl 3050 0
112.112.112.2 -/B/-/ 2 110.1.1.2 Vl 3050 0
Supported
Releases
10.2.0E or later
summary-address
Configures a summary address for an ASBR to advertise one external route as an aggregate for all redistributed routes covered
by a specified address range.
Syntax
summary-address ip-address/mask [not-advertise | tag tag-value]
Parameters
ip-address/maskEnter the IP address to summarize along with the mask.
not-advertise(Optional) Suppresses IP addresses that do not match the network prefix/mask.
tag-value(Optional) Enter a value to match the routes redistributed through a route map, from 1
to 65535.
Default) Not configured
Command Mode ROUTER-OSPF
Usage
Information
The no version of this command disables the summary address.
Example
OS10(config)# router ospf 100
OS10(config-router-ospf-100)# summary-address 10.0.0.0/8 not-advertise
Supported
Releases
10.3.0E or later
timers lsa arrival
Configures the LSA acceptance intervals.
Syntax
timers lsa arrival arrival-time
Parameters arrival-time Set the interval between receiving the LSA in milliseconds, from 0 to 600,000.
Default 1000 milliseconds
Command Mode ROUTER-OSPF
Usage
Information
Setting the LSA arrival time between receiving the LSA repeatedly ensures that the system gets enough
time to accept the LSA. The no version of this command resets the value to the default.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# timers lsa arrival 2000
Supported
Releases
10.2.0E or later
timers spf
Enables shortest path first (SPF) throttling to delay an SPF calculation when a topology change occurs.
Syntax
timers spf [start-time [hold-time [max-wait]]]
Parameters
start-time Sets the initial SPF delay in milliseconds, from 1 to 600000; default 1000.
hold-time Sets the additional hold time between two SPF calculations in milliseconds, from 1 to
600000; default 10000.
max-wait Sets the maximum wait time between two SPF calculations in milliseconds, from 1 to
600000; default 10000.
Layer 3 969