Users Guide

Supported
Releases
OS10 legacy command.
default-information originate
Generates and distributes a default external route information to the OSPFv3 routing domain.
Syntax
default-information originate [always]
Parameters always — (Optional) Always advertise the default route.
Defaults Disabled
Command Mode ROUTER-OSPFv3
Usage
Information
The no version of this command disables the distribution of default route.
Example
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# default-information originate always
Supported
Releases
10.3.0E or later
ipv6 ospf area
Attaches an interface to an OSPF area.
Syntax
ipv6 ospf process-id area area-id
Parameters
● process-id—Enter an OSPFv3 process ID for a specific OSPFv3 process, from 1 to 65535.
● area-id—Enter the OSPFv3 area ID in dotted decimal A.B.C.D format or enter an area ID number,
from 1 to 65535.
Default Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command removes an interface from an OSPFv3 area.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# ipv6 ospf 10 area 1
Supported
Releases
10.3.0E or later
ipv6 ospf authentication
Configures OSPFv3 authentication on an IPv6 interface.
Syntax
ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1} key}
Parameters
● null — Prevents area authentication from being inherited on the interface.
● ipsec spi number — Enter a unique security policy index number, from 256 to 4294967295.
● md5 — Enable MD5 authentication.
● sha1 — Enable SHA1 authentication.
● key — Enter the text string used by the authentication type.
Default IPv6 OSPF authentication is not configured on an interface.
Command Mode INTERFACE
982 Layer 3