Concept Guide

Figure 83. Conguring LLDP
Viewing the LLDP Conguration
To view the LLDP conguration, use the following command.
• Display the LLDP conguration.
CONFIGURATION or INTERFACE mode
show config
Examples of Viewing LLDP Congurations
The following example shows viewing an LLDP global conguration.
DellEMC(conf)#protocol lldp
DellEMC(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 10
no disable
DellEMC(conf-lldp)#
DellEMC(conf-lldp)#exit
DellEMC(conf)#interface tengigabitethernet 1/31
DellEMC(conf-if-te-1/31)#show config
!
interface TenGigabitEthernet 1/31
no ip address
switchport
no shutdown
DellEMC(conf-if-te-1/31)#protocol lldp
DellEMC(conf-if-te-1/31-lldp)#show config
!
protocol lldp
DellEMC(conf-if-te-1/31-lldp)#
Viewing Information Advertised by Adjacent LLDP
Neighbors
To view brief information about adjacent devices or to view all the information that neighbors are advertising, use the following commands.
564
Link Layer Discovery Protocol (LLDP)