Owners Manual

NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop
and the destination port-channel is shut down, the traffic is dropped. However, on the S-Series, the
traffic redirected to the destination port-channel is sometimes switched.
Use the following command inINTERFACE mode to apply a redirect list to an interface. Multiple redirect-
lists can be applied to a redirect-group. It is also possible to create two or more redirect-groups on one
interface for backup purposes.
Command Syntax Command Mode Purpose
ip redirect-group redirect-list-name INTERFACE Apply a redirect list (policy-based routing) to
an interface.
redirect-list-name is the name of a redirect
list to apply to this interface.
FORMAT: up to 16 characters
Delete the redirect list from this interface with the [no] ip
redirect-group command.
In this example, the list “xyz” is applied to the tenGigabitEthernet 2/1 interface.
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-2/1)#ip redirect-group xyz
Dell(conf-if-te-2/1)#
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-1/1)#ip redirect-group test
Dell(conf-if-te-1/1)#ip redirect-group xyz
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/2)#
Dell(conf-if-gi-1/1)#ip redirect-group test
Dell(conf-if-gi-1/1)#ip redirect-group xyz
Dell(conf-if-gi-1/1)#show config
!
interface GigabitEthernet 1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/2)#
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are
supported on a single interface. Dell Networking OS has the capability to support multiple groups on an
interface for backup purposes.
Show Redirect List Configuration
700
Policy-based Routing (PBR)