Reference Guide

Local FCOE PriorityMap is 0x8
Local ISCSI PriorityMap is 0x10
Remote FCOE PriorityMap is 0x8
Remote ISCSI PriorityMap is 0x8
0 Input TLV pkts, 1 Output TLV pkts, 0 Error pkts, 0 Pause Tx pkts, 0 Pause Rx
pkts
The following table describes the show interface pfc summary command fields.
Table 15.
show interface pfc summary Command Description
Fields Description
Interface Interface type with stack-unit and port number.
Admin mode is on; Admin is enabled PFC Admin mode is on or off with a list of the configured
PFC priorities . When PFC admin mode is on, PFC
advertisements are enabled to be sent and received from
peers; received PFC configuration takes effect. The admin
operational status for a DCBx exchange of PFC
configuration is enabled or disabled.
Remote is enabled; Priority list Remote Willing Status is
enabled
Operational status (enabled or disabled) of peer device for
DCBx exchange of PFC configuration with a list of the
configured PFC priorities. Willing status of peer device for
DCBx exchange (Willing bit received in PFC TLV): enabled
or disabled.
Local is enabled DCBx operational status (enabled or disabled) with a list of
the configured PFC priorities
Operational status (local port) DCBx operational status (enabled or disabled) with a list of
the configured PFC priorities.
Port state for current operational PFC configuration:
• Init: Local PFC configuration parameters were
exchanged with peer.
• Recommend: Remote PFC configuration
parameters were received from peer.
• Internally propagated: PFC configuration
parameters were received from configuration
source.
PFC DCBx Oper status Operational status for exchange of PFC configuration on
local port: match (up) or mismatch (down).
State Machine Type Type of state machine used for DCBx exchanges of PFC
parameters:
• Feature: for legacy DCBx versions
• Symmetric: for an IEEE version
TLV Tx Status Status of PFC TLV advertisements: enabled or disabled.
PFC Link Delay Link delay (in quanta) used to pause specified priority
traffic.
261