Reference Guide

Example of Copying a File to an FTP Server

FTOS#copy flash://FTOS-EF-8.2.1.0.bin ftp://myusername:mypassword@10.10.10.10/

/FTOS/FTOS-EF-8.2.1.0

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

27952672 bytes successfully copied

Example of Importing a File to the Local System

core1#$//copy ftp://myusername:mypassword@10.10.10.10//FTOS/

FTOS-EF-8.2.1.0.bin flash://

Destination file name [FTOS-EF-8.2.1.0.bin.bin]:

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

26292881 bytes successfully copied

Save the Running-Configuration

The running-configuration contains the current system configuration. Dell Networking recommends coping your

running-configuration to the startup-configuration.

The system uses the startup-configuration during boot-up to configure the system. The startup-configuration is stored in

the internal flash on the primary RPM by default, but it can be saved onto an external flash (on an RPM) or a remote

server.

The commands in this section follow the same format as those commands in the Copy Files to and from the System

section but use the filenames startup-configuration and running-configuration. These commands assume that current

directory is the internal flash, which is the system default.

• Save the running-configuration to the startup-configuration on the internal flash of the primary RPM.

EXEC Privilege mode

copy running-config startup-config

• Save the running-configuration to the internal flash on an RPM.

EXEC Privilege mode

copy running-config rpm{0|1}flash://filename

NOTE: The internal flash memories on the RPMs are synchronized whenever there is a change, but only if the

RPMs are running the same version of FTOS.

• Save the running-configuration to the external flash of an RPM.

EXEC Privilege mode

copy running-config rpm{0|1}slot0://filename

• Save the running-configuration to an FTP server.

EXEC Privilege mode

copy running-config ftp:// username:password@{hostip | hostname}/filepath/

filename

• Save the running-configuration to a TFTP server.

EXEC Privilege mode

copy running-config tftp://{hostip | hostname}/ filepath/filename

• Save the running-configuration to an SCP server.

EXEC Privilege mode

copy running-config scp://{hostip | hostname}/ filepath/filename

NOTE: When copying to a server, a host name can only be used if a DNS server is configured.

• Save the running-configuration to the startup-configuration on the internal flash of the primary RPM. Then copy the

new startup-config file to the external flash of the primary RPM.

EXEC Privilege mode