Reference Guide

– local7 (for local use)
– lpr (for line printer system messages)
– mail (for mail system messages)
– news (for USENET news messages)
– sys9 (system use)
– sys10 (system use)
– sys11 (system use)
– sys12 (system use)
– sys13 (system use)
– sys14 (system use)
– syslog (for syslog messages)
– user (for user programs)
– uucp (UNIX to UNIX copy protocol)
To view nondefault settings, use the show running-config logging command in EXEC mode.
Example of the show running-config logging Command
FTOS#show running-config logging
!
logging buffered 524288 debugging
service timestamps log datetime msec
service timestamps debug datetime msec
!
logging trap debugging
logging facility user
logging source-interface Loopback 0
logging 10.10.10.4
FTOS#
Synchronizing Log Messages
You can configure FTOS to filter and consolidate the system messages for a specific line by synchronizing the message
output.
Only the messages with a severity at or below the set level appear. This feature works on the terminal and console
connections available on the system.
1. Enter LINE mode.
CONFIGURATION mode
line {console 0 | vty number [end-number] | aux 0}
Configure the following parameters for the virtual terminal lines:
– number: the range is from zero (0) to 8.
– end-number: the range is from 1 to 8.
You can configure multiple virtual terminals at one time by entering a number and an end-number .
2. Configure a level and set the maximum number of messages to print.
LINE mode
logging synchronous [level severity-level | all] [limit]
Configure the following optional parameters:
60