Reference Guide

Creating an Input QoS Policy
To create an input QoS policy, use the following steps.
1. Create a Layer 3 input QoS policy.
CONFIGURATION mode
qos-policy-input
Create a Layer 2 input QoS policy by specifying the keyword layer2 after the qos-policy-input command.
2. After you create an input QoS policy, do one or more of the following:
Configuring Policy-Based Rate Policing
Setting a DSCP Value for Egress Packets
Setting a dot1p Value for Egress Packets
Configuring Policy-Based Rate Policing
To configure policy-based rate policing, use the following command.
• Configure rate police ingress traffic.
QOS-POLICY-IN mode
rate-police
Setting a dot1p Value for Egress Packets
To set a dot1p value for egress packets, use the following command.
• Set a dot1p value for egress packets.
QOS-POLICY-IN mode
set mac-dot1p
Creating an Output QoS Policy
To create an output QoS policy, use the following commands.
1. Create an output QoS policy.
CONFIGURATION mode
qos-policy-output
2. After you configure an output QoS policy, do one or more of the following:
Configuring Policy-Based Rate Limiting
Allocating Bandwidth to Queue
Specifying WRED Drop Precedence
Configuring Policy-Based Rate Shaping
To configure policy-based rate shaping, use the following command.
• Configure rate shape egress traffic.
QOS-POLICY-OUT mode
rate-shape
Allocating Bandwidth to Queue
Schedule packets for egress based on Deficit Round Robin (DRR). These strategies both offer a guaranteed data rate.
The following table lists the default bandwidth weights for each queue, and their equivalent percentage which is derived
by dividing the bandwidth weight by the sum of all queue weights.
649