Reference Guide

redistribute {connected | static} [metric metric-value] [route-map map-name]
– metric-value: the range is from 0 to 16.
– map-name: the name of a configured route map.
• Include IS-IS routes in RIP.
ROUTER RIP mode
redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value]
[route-map map-name]
– metric-value: the range is from 0 to 16.
– map-name: the name of a configured route map.
• Include specific OSPF routes in RIP.
ROUTER RIP mode
redistribute ospf process-id [match external {1 | 2} | match internal]
[metric value] [route-map map-name]
Configure the following parameters:
– process-id: the range is from 1 to 65535.
– metric: the range is from 0 to 16.
– map-name: the name of a configured route map.
To view the current RIP configuration, use the show running-config command in EXEC mode or the show
config command in ROUTER RIP mode.
Setting the Send and Receive Version
To change the RIP version globally or on an interface in FTOS, use the following command.
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or
the other version, use the
ip rip send version or the ip rip receive version commands in
INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP traffic on
the interfaces participating in RIP unless the interface was specifically configured for a specific RIP version.
• Set the RIP version sent and received on the system.
ROUTER RIP mode
version {1 | 2}
• Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
• Set the RIP versions sent out on that interface.
INTERFACE mode
ip rip send version [1] [2]
To see whether the version command is configured, use the show config command in ROUTER RIP mode. To
view the routing protocols configuration, use the show ip protocols command in EXEC mode.
The following example shows the RIP configuration after the ROUTER RIP mode version command is set to
RIPv2. When you set the
ROUTER RIP mode version command, the interface (GigabitEthernet 0/0) participating in
the RIP process is also set to send and receive RIPv2 (shown in bold).
Example of an Interface Participating in the RIP Process
FTOS#show ip protocols
663