Reference Guide

C 10.200.10.0/24 Direct, Gi 2/41 0/0 00:03:03
C 10.300.10.0/24 Direct, Gi 2/42 0/0 00:02:42
R 192.168.1.0/24 via 10.11.20.1, Gi 2/31 120/1 00:01:20
R 192.168.2.0/24 via 10.11.20.1, Gi 2/31 120/1 00:01:20
Core2#
R 192.168.1.0/24 via 10.11.20.1, Gi 2/31 120/1 00:05:22
R 192.168.2.0/24 via 10.11.20.1, Gi 2/31 120/1 00:05:22
Core2#
Example of the show ip protocols Command to Show RIP Configuration Activity on Core 2
Core2#show ip protocols
Routing Protocol is "RIP"
Sending updates every 30 seconds, next due in 17
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
GigabitEthernet 2/42 2 2
GigabitEthernet 2/41 2 2
GigabitEthernet 2/31 2 2
GigabitEthernet 2/11 2 2
Routing for Networks:
10.300.10.0
10.200.10.0
10.11.20.0
10.11.10.0
Routing Information Sources:
Gateway Distance Last Update
10.11.20.1 120 00:00:12
Distance: (default is 120)
Core2#
RIP Configuration on Core3
The following example shows how to configure RIPv2 on a host named Core3.
Example of Configuring RIPv2 on Core3
Core3(conf-if-gi-3/21)#router rip
Core3(conf-router_rip)#version 2
Core3(conf-router_rip)#network 192.168.1.0
Core3(conf-router_rip)#network 192.168.2.0
Core3(conf-router_rip)#network 10.11.30.0
Core3(conf-router_rip)#network 10.11.20.0
Core3(conf-router_rip)#show config
!
router rip
network 10.0.0.0
network 192.168.1.0
network 192.168.2.0
version 2
Core3(conf-router_rip)#
668