Reference Guide

• FTOS supports only one Rapid Spanning Tree (RST) instance.
• All interfaces in virtual local area networks (VLANs) and all enabled interfaces in Layer 2 mode are
automatically added to the RST topology.
• Adding a group of ports to a range of VLANs sends multiple messages to the rapid spanning tree protocol (RSTP)
task, avoid using the range command. When using the range command, Dell Networking recommends
limiting the range to five ports and 40 VLANs.
RSTP and VLT
Virtual link trunking (VLT) provides loop-free redundant topologies and does not require RSTP.
RSTP can cause temporary port state blocking and may cause topology changes after link or node failures. Spanning
tree topology changes are distributed to the entire Layer 2 network, which can cause a network-wide flush of learned
media access control (MAC) and address resolution protocol (ARP) addresses, requiring these addresses to be re-
learned. However, enabling RSTP can detect potential loops caused by non-system issues such as cabling errors or
incorrect configurations. RSTP is useful for potential loop detection but to minimize possible topology changes after link
or node failure, configure it using the following specifications.
The following recommendations help you avoid these issues and the associated traffic loss caused by using RSTP when
you enable VLT on both VLT peers:
• Configure any ports at the edge of the spanning tree’s operating domain as edge ports, which are directly
connected to end stations or server racks. Ports connected directly to Layer 3-only routers not running STP
should have RSTP disabled or be configured as edge ports.
• Ensure that the primary VLT node is the root bridge and the secondary VLT peer node has the second-best
bridge ID in the network. If the primary VLT peer node fails, the secondary VLT peer node becomes the root
bridge, avoiding problems with spanning tree port state changes that occur when a VLT node fails or recovers.
• Even with this configuration, if the node has non-VLT ports using RSTP that are not configured as edge ports and
are connected to other layer 2 switches, spanning tree topology changes can still be detected after VLT node
recovery. To avoid this scenario, ensure that you configure any non-VLT ports as edge ports or have RSTP
disabled.
Configuring Interfaces for Layer 2 Mode
To configure and enable interfaces in Layer 2 mode, use the following commands.
All interfaces on all bridges that participate in Rapid Spanning Tree must be in Layer 2 and enabled.
1. If the interface has been assigned an IP address, remove it.
INTERFACE mode
no ip address
2. Place the interface in Layer 2 mode.
INTERFACE mode
switchport
3. Enable the interface.
INTERFACE mode
no shutdown
To verify that an interface is in Layer 2 mode and enabled, use the show config command from INTERFACE mode.
The bold lines indicate that the interface is in Layer 2 mode.
Example of Verifying an Interface is in Layer 2 Mode and Enabled
FTOS(conf-if-gi-1/1)#show config
!
678