Reference Guide

Example of Verifying Extended sFlow Disabled
FTOS#show sflow
sFlow services are disabled
Global default sampling rate: 32768
Global default counter polling interval: 20
Global extended information enabled: none
0 collectors configured
0 UDP packets exported
0 UDP packets dropped
0 sFlow samples collected
0 sFlow samples dropped due to sub-sampling
Enabling and Disabling sFlow on an Interface
By default, sFlow is disabled on all interfaces.
This CLI is supported on physical ports and link aggregation group (LAG) ports.
To enable sFlow on a specific interface, use the following command.
• Enable sFlow on an interface.
INTERFACE mode
[no] sflow enable
To disable sFlow on an interface, use the no version of this command.
sFlow Show Commands
FTOS includes the following sFlow display commands.
• Displaying Show sFlow Globally
• Displaying Show sFlow on an Interface
• Displaying Show sFlow on a Line Card
Displaying Show sFlow Global
To view sFlow statistics, use the following command.
• Display sFlow configuration information and statistics.
EXEC mode
show sflow
The first bold line indicates sFlow is globally enabled.
The second bold lines indicate sFlow is enabled on linecards Gi 1/16 and Gi 1/17
Example of Viewing sFlow Configuration (Global)
FTOS#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 6343
77 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
69 sFlow samples dropped due to sub-sampling
735