Users Guide
NOTE: VRF based ACL congurations are not supported on the egress trac.
Example of Applying ACL Rules to Egress Trac and Viewing ACL Conguration
To specify ingress, use the out keyword. Begin applying rules to the ACL with the ip access-list extended abcd 
command. To view the access-list, use the show command.
Dell(conf)#interface TenGigabitEthernet 1/1
Dell(conf-if-te-1/1)#ip access-group abcd out
Dell(conf-if-te-1/1)#show config
!
TenGigabitEthernet 1/1
 no ip address
 ip access-group abcd out
 no shutdown
Dell(conf-if-te-1/1)#end
Dell#configure terminal
Dell(conf)#
ip access-list extended abcd
Dell(config-ext-nacl)#permit tcp any any
Dell(config-ext-nacl)#deny icmp any any
Dell(config-ext-nacl)#permit 1.1.1.2
Dell(config-ext-nacl)#end
Dell#show ip accounting access-list
!
Extended Ingress IP access list abcd on tengigabitethernet 0/0
 seq 5 permit tcp any any
 seq 10 deny icmp any any
seq 15 permit 1.1.1.2
Dell#configure terminal
Dell(conf)#interface te 1/2
Dell(conf-if-te-1/2)#ip vrf forwarding blue
Dell(conf-if-te-1/2)#show config
!
interface TenGigabitEthernet 1/2
ip vrf forwarding blue
no ip address
shutdown
Dell(conf-if-te-1/2)#
Dell(conf-if-te-1/2)#
Dell(conf-if-te-1/2)#end
Dell#
Applying Egress Layer 3 ACLs (Control-Plane)
By default, packets originated from the system are not ltered by egress ACLs.
For example, if you initiate a ping session from the system and apply an egress ACL to block this type of trac on the interface, the 
ACL does not aect that ping trac. The Control Plane Egress Layer 3 ACL feature enhances IP reachability debugging by 
implementing control-plane ACLs for CPU-generated and CPU-forwarded trac. Using permit rules with the 
count option, you can 
track on a per-ow basis whether CPU-generated and CPU-forwarded packets were transmitted successfully.
NOTE: The ip control-plane [egress filter] and the ipv6 control-plane [egress filter] 
commands are not supported.
1. Apply Egress ACLs to IPv4 system trac.
CONFIGURATION mode
ip control-plane [egress filter]
2. Apply Egress ACLs to IPv6 system trac.
CONFIGURATION mode
ipv6 control-plane [egress filter]
3. Create a Layer 3 ACL using permit rules with the count option to describe the desired CPU trac.
Access Control Lists (ACLs)
123










