Owners Manual

• For TIA-1057 TLVs:
– guest-voice
– guest-voice-signaling
– location-identification
– power-via-mdi
– softphone-voice
– streaming-video
– video-conferencing
– video-signaling
– voice
– voice-signaling
NOTE: The vlan-name command is supported on S4810 S4820T systems only.
In the following example, LLDP is enabled globally. R1 and R2 are transmitting periodic LLDPDUs that
contain management, 802.1, and 802.3 TLVs.
Figure 77. Configuring LLDP
Viewing the LLDP Configuration
To view the LLDP configuration, use the following command.
• Display the LLDP configuration.
CONFIGURATION or INTERFACE mode
show config
Examples of Viewing LLDP Configurations
Dell(conf)#protocol lldp
Dell(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
Link Layer Discovery Protocol (LLDP)
571