Reference Guide

• For a 40–Gigabit Ethernet interface, enter fortyGigE
slot/port.
• For a VLAN interface, enter vlan vlan-id. The valid
VLAN IDs range is from 1 to 4094.
Defaults No default behavior or values.
Command Modes
EXEC
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1.(0.0) Introduced on the S4810 and Z9000.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Version 8.3.19.0 Introduced on the S4820T.
Usage
Information
The show crypto ipsec sa ipv6 command output displays security associations set
up for OSPFv3 links in IPsec authentication and encryption policies on the router.
Related
Commands
show crypto ipsec policy – displays the configuration of IPsec authentication and encryption
policies.
Example
FTOS#show crypto ipsec policy
FTOS#show crypto ipsec sa ipv6
Interface: TenGigabitEthernet 0/0
Link Local address: fe80::201:e8ff:fe40:4d10
IPSecv6 policy name: OSPFv3-1-500
inbound ah sas
spi : 500 (0x1f4)
transform : ah-md5-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
outbound ah sas
spi : 500 (0x1f4)
transform : ah-md5-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
inbound esp sas
outbound esp sas
Interface: TenGigabitEthernet 0/1
Link Local address: fe80::201:e8ff:fe40:4d11
IPSecv6 policy name: OSPFv3-1-600
inbound ah sas
1018